air purifiers, fume extractors, dust collectors, dust, chemical odor removal
Shipped direct to you factory fresh , North America Toll Free 1-800-626-0664
We're Your Source of Genuine Quatro Air Filters and Parts
HEPA Filters, Bag Filters, Dust Pre-Filters, Chemical Odor Filters, Bulk Chemical Media, Motors, UV Light, etc.
Laser Marking, Engraving, Cutting - captures laser smoke and fumes at source using small diameter tip extraction, high pressure blower / motor, 8" deep bed chemical gas odor filter
The SPH426 Fume Extractor by Quatro Air is a self contained unit, that connects to the laser engraver via flexible heavy duty grounded hose that is provided.
This is a self contained unit, that connects to the laser engraver via flexible heavy duty grounded hose that is provided. The inlet diameter can accommodate a 2", 3" or 4" collar hose connection.
Discharge is recirculated back into the room via vents at
the bottom of the system. However, there is an optional side collar adapter kit to allow venting to the exterior if required. The unit is very quiet, and takes
up very little floor space (approx. 1.25 sq. ft.) At 30 inches high the unit is
ideal to be tucked under a table. This can save precious floor space. If required,
the entire system is easily relocated via industrial grade casters on the
bottom of the exhaust unit. All the filter elements can be replaced without the
need for tools in very short order. The inexpensive filters make this an
economical solution for most end users.
This unit is easily assembled, requires no tools, no need
for a technician. The deep bed chemical filter allows for maximum VOC removal.
The chemical filter is lowered in from the top lid. The 99.97%
HEPA filter guarantees the removal of particles as small as 0.3 microns in
diameter.
The SPH400 Fume Extractor and Air Filtration System is designed with up to 4 stages of
filtration each targeted for removal of specific size particles and gases.
There are a series of filters in the system to ensure
that all particulate matter/ dust is removed efficiently:
Particulate Filtration:
The unit contains multi-layer knock out pad filters, Deep
Pleated high capacity safety filters and a MERV 17 99.97 % HEPA filter.
The HEPA filter is the last particulate filter in the
sequence and it is designed to remove 99.97% of all particulate matter that is
0.3 microns and larger.
This is the same type of filter that is used in hospital
operating rooms.
Please note as the filters begin to get dirty they also become
more efficient making the system more efficient as time goes on.
This occurs as
it gets more and more difficult for the dust to pass through the filter due to
the passages becoming smaller as they become filled with debris.
Gas Phase Chemical Fume Odor Filtration:
The gas phase filter is quite large and 8” deep in
direction of airflow.
We have 26 different types of chemical media that can be
incorporated into the chemical filter to address and deal with specific
contaminants if required.
Depending on the type of media the modules could weigh as
much as 40 lbs.
Our standard and most typical module contains a virgin
bituminous coal extruded 3-4 mm carbon pellet.
This carbon is ideal at removing many VOC’s and has a
holding capacity as high as 25 % by weight. Initially the removal efficiency
will be 100% for most VOC’s. Over time the mass transfer zone will travel
through the chemical filter as it gets consumed.
The chemical filter is seated inside a gel seal material to guarantee zero by-pass of the chemical filter. This is the same material
that is used in Pharmaceutical and Hospital environment clean rooms. All gases
therefore must pass through the chemical filter.
Unlike other systems that have a sprinkling of carbon our
gas phase chemical filter is quite large and requires the use of high pressure
blowers to overcome the resistance created by the deep bed chemical filter.
Our
blowers are capable of generating 90” water column of pressure. With this type
of blower as the filters begin to get dirty and plugged we can still
effectively overcome this increase in pressure.
The system is equipped to
advise you when the filters need to be changed.
|Filter Sequences Available / Specs Dual Infinity Motors|Filter Sequences / Specs - Brushless Motor|SPH426 Laser Fume Extractor PDF|
Genuine Quatro Air Replacement Filters
